Cheapest web hosting - Although one side must dial out while the
Although one side must dial out while the other side must receive the call to create a PPP connection over a modem, after the connection is established, information can flow in both directions. For the sake of clarity, however, I refer to the computer placing the call as the client and the computer receiving the call as the server. To simplify the process of configuring PPP (and other network interfaces), Red Hat Linux provides a dial-up configuration tool for both the GNOME and KDE interfaces. Those interfaces are, respectively, as follows: Dialup Configuration Tool From the GNOME desktop menu, choose Programs Internet Dialup Configuration. The Internet Connection window that appears lets you configure and test your dial-up PPP connection. Kppp Window From the KDE desktop menu, choose Internet Internet Dialer. This runs the kppp command. From the kppp window you can set up a PPP dial-up connection and launch it. Before you begin either of the two dial-up procedures, physically connect your modem to your computer, plug it in, and connect it to your telephone line. If you have an internal modem, you will probably see a telephone port on the back of your computer that you need to connect. After the modem is connected, reboot Red Hat Linux so it can automatically detect and configure your modem. Creating a dial-up connection from GNOME To configure dial-up networking from the GNOME desktop, you should use the Dialup Configuration window. To start it, choose Programs Internet Dialup Configuration from the GNOME menu. A connection wizard appears to help you configure your PPP dial-up connection, as shown in Figure 16-1. Figure 16-1: The Dialup Configuration Tool steps you through a PPP Internet connection. Follow the procedure below from the first Dialup Configuration Tool window to configure your dial-up connection. 1. From the Add New Internet Connection window that appears, click Next to continue. If you do not have a modem configured, you are asked if you want to configure one. 2. Click Next to configure a modem. A pop-up window searches your computer for a modem. If it finds your modem, its location will be filled in on the Enter a modem window. Otherwise, you will have to enter the location of the modem yourself. 3.
Note: In case you are looking for affordable and reliable webhost to host and run your j2ee application check Vision web and email hosting services